The Lizard pumpkin lasted only a couple of days before it melted and fell apart.
I decided to try another tessellation using only two "colors", black and orange.
This allows me to keep the pumpkin's structural support while still showing a pattern.
I drew the design on paper and wrapped it over the pumpkin.
I did have to adjust the top and bottom to work with the spherical shape of the pumpkin.
Applying much pressure to a pen, I traced over the pattern and pressed the design into the
pumpkin. I took the paper off of the pumpkin and went over it again with the pen.
Next, I trace the design with a utility knife.
The blue tape indicates the part of the design that will remain on the pumpkin.
I carved out the areas that had no tape. The cut is only about 1/2 inch into the surface.